I have been installing BGM 4 post regulators on scooters for years and every time I do it, I get irritated that the regulator is designed to use a specific plug on the wiring harness but I am only provided spade connections. This leads to a very ugly wiring setup with spaghetti all over the place, which drives me bananas.
Does the regulator work as it should? Sure
Does it look amateur when all wired up, even under the cleanest of installations? You bet
To address this, we have released 2 separate products that should cover all of your wiring needs.
The first one is our complete 12V Regulator/Rectifier Kit.
This kit includes:
Same great quality voltage regulator as you are already familiar with
The correct wiring harness side plug
5 snap-lock female spade connections for the plug
2 complete bullet connectors with covers.
Our 2nd product addresses the issue of if you already have a BGM voltage regulator and want to clean up your installation so it looks as good as our complete kit when fitted.
Our 12V Voltage Regulator Plug Kit includes:
The correct wiring harness side plug
5 snap-lock female spade connections for the plug
2 complete bullet connectors with covers.
There is nothing worse than a beautiful vintage scooter with ugly wiring. Regulate, and wire like a Boss with Piston Ported.